Universal Motorcycles Cruise Control Throttle Lock Assist Clamp,Motorcycle Hand Rest Control Grip Accelerator Assistant with 3 Hex Key and 1 Pieces Replaceable Screws for 1″ & 7/8″ Handlebar

Universal fitment: Interchangeable rubber inserts allow use with most grip configurations (7/8″ and 1″ handlebars for OEM grips; Aftermarket grips with minimum 1 1/8″ to maximum 1 3/4″ outside grip diameter)
High Quality Material: Made from durable nylon and rubber; Simple design emphasizes reliable function over flashy styling
Easy to install: With our mounting instruction you can easily install the cruise control kit and gain all the functions in 15 minutes
Safe and effective: Say goodbye to some complicated hand gestures when riding on highway, just press down/up the switch to gain innovative throttle assist
Anti-fatigue: Relax your grip on the throttle, making pins and needles and fatigue a distant memory BILLFARO Universal Motorcycles Cruise Control Throttle Lock Assist
Specifications:
Material: High quality nylon and rubber
Package Included :
1 x motorcycle cruise control throttle assist set
3 x Hex Key
1 x Replaceable Screw
Feature:
1.Suitable for 7/8″ and 1″ handlebars for motorcycle OEM grips
2.Motorcycle grips with minimum 1 1/8″ to maximum 1 3/4″ outside grip diameter
3.Interchangeable rubber inserts is allowed to be used for most motorcycle grip accessories (including some electric motorcycles)
Note:
Technically this cruise control universal for motorcycles. Please check our dimension diagram and measure your motorcycle handlebars to make sure it can fits.
Step
Step 1:Read understand all steps in the instructions before starting the installation.Park the motorcycle on a hard,level surface.turn off the ignition and allow the engine to cool.
Step 2:Slide the nylon collar assembly with handlebar top clamp over the end of the throttle.Loosely fasten the handlebar bottom clamp to the top clamp around the handlebar.
Step 3:Determine if the arm spacer will be necessary.The arm spacer will need to be used if the standard length arm does not clear the handlebar controls and allow the handlebar top and bottom clamp to wrap around the handlebar while the nylon collar assembly is around the grip.
Step 4:Select correct rubber collar(small ,medium or large).Test fit the rubber collar around the grip.The collar should fit around the grip without a large gap or overlapping ends.
Step
Step 5:Insert the correct sized rubber collar between the nylon collar and grip.Place the “joint of the rubber collar on the bottom side midway between two set screws on the nylon collar.Tighten the top /bottom clamp around the handlebar.
Step 6:Twist the throttle to ensure there is no binding and the throttle will return to the closed position.Make sure that the tension collar is in-line with nylon collar and grip,incorrect adjustment may cause the throttle to stick in the open position.
Step 7:Rotate the throttle assist arm and thumb lever to the desired position.Retighten the top/bottom clamp in desired position .The thumb lever should bein a position for easy access.
Step 8:Tighten the 3 set screw on the nylon collar until the screws are flush with the collar.