Pack of 2 Aluminum Housing Red LED Trailer Stop Brake Turn Tail Lights, AT-HAIHAN DOT Compliant Waterproof Surface Mount Lighting for Truck Tractor Jeep RV

4.4″ x 1.6″ Oblong; waterproof LED trailer taillight acts as stop, turn, and tail signal lights when properly mounted; suitable for trucks, trailers, tractors, MPVs, RV and buses
Ultra slim, die-casting aluminum housing with durable red polycarbonate lens over red LEDs, resistant to shock and vibration
DOT compliant safety light; built-in 12 PCS SMD LEDs, features premium optics to output super bright red light, high brightness for turn or brake light, low brightness for tail light, making them ideal for front or rear vehicle applications, improve visibility at night, in fog or raining day
Low-profile design, comes with gasket and mounting screws for surface mount, can be stacked vertically or horizontally to improve visibility where required
Support 12V DC input only with 3 wire design, red wire for turn signal or brake light, black wire for tail light, white wire for ground; 24 months manufacture & seller warranty with 60 days money-back or replacement service Specification
Light Source: 12 PCS SMD2835 LEDs
Working Voltage: 12V DC
Housing Material: Aluminum alloy
Lens Material: Polycarbonate
Lens Shape: Oval
Lens Color: Red
Mount Type: Surface mount
Waterproof rate: IP66
Wiring connection: Red – Turn signal and brake; Black – Tail light; White ?C Ground
What’s in the box: 2 x 4.4″ Oblong Tail Lights; 2 x 4.4″ Oblong Rubber Gasket; Mounting Screws; Instruction Manual
LED turn signal tail side marker light for truck trailer running board
Installation
1. Determine the mounting location for the AT-HAIHAN tail light should be mounted to a flat surface or one with the least amount of curvature.
2. Using the supplied mounting gasket as a template mark the drill hole locations on the mounting surface for either front or rear mounting.
3. Three holes to be drilled out by using correct drill bit the middle hole needs to be bigger than the others then remove any sharp edges from these holes.
4. Mount the tail light along with the mounting gasket routing the wires through the middle hole.