36″ for LS Braided Throttle Cable Kit Fit for Chevrolet for Chevy 1997-2007 for LS1 Engine 4.8L 5.3L 5.7L 6.0L for LS Swap Fuel Line Kit Stainless Steel Gas Cable Accelerator Cable

Fitment For Chevrolet for Chevy for LS1 Engines 5.7L 1997-2004, for Chevrolet for Chevy for LS1 Engines 4.8/5.3/6.0L 1999-2007. For who want to set for LS Swap.
Usage of 36″ Stainless Steel Throttle Cable 36″ outer housing & 47.24″ total length. It can easily be cut for any length for custom fit(remove the ferrule to cut). Adapted to most accelerator pedals and throttle assemblies.
Features for LS Braided Throttle Cable Kit Operated with a smooth, no-bind cable, adopting durable quality stainless steel and specially extruded liner, tubular protective layer to better protects the smooth and non-binding cable inside, runs smoothly after long-term use, which extends the service life of the cable.
Composition of Throttle Cable Kit This item is composed of inner wire, braided stainless steel cable housing, throttle body fitting, throttle cable adjuster, adjuster nut, ferrule, throttle cable, suit for your custom use.
Package Include 1x 36″ Braided Throttle Cable, 1x Wrench. Please confirm your car mode, engine, appearance of the original part especial ends before purchasing. And check relevant operation video when you replace it in doubt. 36″ for LS Braided Throttle Cable Kit Fit for LS1 Engine 4.8L 5.3L 5.7L 6.0L for LS Swap Fuel Line Kit Stainless Steel
Specification
Condition: NewMaterial: Stainless SteelColor: Silver ToneWire Total Length (In): 47.24″/120cmOutside Housing Length (In): 36″/91cmFitment Type: Direct replacementInclude: 1x Braided Throttle Cable Kit, 1x Wrench
Throttle Cable Adjuster
Extruded liner and tubular protective layer, to protect inner cable, prolong service life
Fixed Internal Cable Regulator
Aluminum fittings and ferrules, aim to eliminate fraying
Weaving Stainless Steel Cable
Stainless inner wire and braided outer housing, easily be cut to any length for custom
Can the ferrule be removed to shorten the braided cable housing
*Please pull forward the ferrule out use tools to cut the tip off and slide back the ferrule or just pull foward it, wrap tape at the place you need to cut (to prevent fraying) make cut, leaving a bit of the tape on the end, carefully slide the ferrule over the freshly cut end.
*It can only shorten not lengthen, please make sure the length is correct before cutting.
Notice
*Please confirm your car mode, engine, appearance of the original part especial ends before purchase.
*Please check relevant video by search “Throttle Cable Replacement” when you replace it in doubt.