Tools Motorcycle/Bike Coil Spring Shock Compressor

Essential for the assembly and disassembly of suspension units.

Suitable for most types of classic and modern motorcycle coil springs. Unsuitable for use on UTV/ATV.

Package included: A pair of compressors,8 spare plastic spring protectors(cannot completely avoid the spring surface be scratched.) Iron box(easy to carry)

2 ways to use- Offer 2 ways to operate. Use with a 3/8″ Sq & 17mm Hex ratchet wrench.

NOTED-Before you order, please make sure the specification by your motorcycle fit our products.Please follow the instructions under before use. Always use proper eye protection when working.
Warning: The tool is designed for use on motorcycle shock shock springs only. Do not use one ATV/UTV or any other application.dont compress the spring uneven, but a little on each side, just enough to remove locking plates etc and above all: DON’T put your fingers where they could get pinched.
Caution:Spring compression and removal can be potentially dangerous. always use protective eyewear when working with tools and keep fingers clear from areas on or around the spring that could pinch them.
Instructions:
1. Make sure that the spring is free of dirt and grease
2. Insert one hook in the last possible upper coil of the spring and the other hook in the last possible lower coil of the spring.
3. install the other spring compressor in the same procedure on the other side of spring. Make sure that the maximum tension distance is reached.
4. Using the wrench to hold the compressor body close to the upper hook area. With the other hand, using a 17mm wrench or a 3/8″ ratchet to tighten the compressor. Both compressors must pressure equally reciprocal.
5. Before removing the shock compressor, check if the damper plate is no longer under tension by the spring. Contents: a pair of compressor??8 spare plastic spring protectors??Iron Box